problem beim Kopierstempel mit "ausgerichtet"

Forum|Forum|2 years ago
November 6, 2023
2 replies
629 views

Hallo,

Ich habe PSE2020.

Beim Kopierstempel hat die Option "ausgerichtet" keine Wirkung auf die Quelle.
Das Kreuz wandert trotzdem mit.

Wie kann ich das ändern?

mfg

BT

Bug

This topic has been closed for replies.

Peru Bob

Community Expert

Is the layer selected?

minktorAuthor

Participating Frequently

Thank you for your answer.
My problem:
I would like the anchor point (cross) to remain at the selected position
and not move with the copy stamp.
In other words: The selected structure should be transferred (filled) to
another larger area. According to my information, this should be
controlled via the "aligned" option (far right). However, switching this
on or off has no effect - the cross always moves with it.
I only have one background layer.
Other solutions are welcomed 🙂
Thank you very much
BT

--
Diese E-Mail wurde von Avast-Antivirussoftware auf Viren geprüft.
www.avast.com

hatstead

Inspiring

Since the Clone stamp tool does not work for you, here is another suggestion.

1. Use the lasso tool or the magnetic lasso tool to select the (source) object.

2. Once the selection is complete, press CTRL+C to copy it to the clipboard

3. Open a blank layer above the Background layer and press CTRL+V to paste the selection on this layer

4. Activate the move tool to place the object at the intended destination.

hatstead

Inspiring

I don't understand the question completely, perhaps due to translation.

The clone stamp tool fetches source pixels which can be deposited elsewhere on your picture. The original source remains without alteration.

Please review the help page for this tool and get back to us if you still have questions. A screen shot would help us to visualize what you see.

Enhance photos (adobe.com)

minktorAuthor

Participating Frequently

Thank you for your answer.
My problem:
I would like the anchor point (cross) to remain at the selected position
and not move with the copy stamp.
In other words: The selected structure should be transferred (filled) to
another larger area. According to my information, this should be
controlled via the "aligned" option (far right). However, switching this
on or off has no effect - the cross always moves with it.
I only have one background layer.

Other solutions are welcomed. 🙂

Thank you very much
BT

--
Diese E-Mail wurde von Avast-Antivirussoftware auf Viren geprüft.
www.avast.com

Sign up

To post, reply, or follow discussions, please sign in with your Adobe ID.

Sign in to Adobe Community

To post, reply, or follow discussions, please sign in with your Adobe ID.

Scanning file for viruses.

This file cannot be downloaded