Skip to main content
S
sc86186330
Participating Frequently
March 7, 2019
Question

Color Correcting with Lumetri Color and the last frame in the timeline does not show the CC

  • March 7, 2019
  • 4 replies
  • 1061 views

Running PP 2019 CC 13.0.3 & just started noticing when color correcting footage - the last frame of each clip doesn't show the color correction applied (whether directly to the clip or on an adjustment layer) on the timeline.

It does export fine, but it's strange to watch playback as every clip, when it gets to the last frame it does not show the color correction applied.

Is this a bug or a setting, if anyone is familiar or also experiencing this issue? Today is the first time I've seen it happening after updating to 13.0.3

This topic has been closed for replies.

4 replies

D
Don334814866z22
Participant
December 30, 2024

I have the exactly the same issue. Seems like the first of the latter clip is effecting the color of the last frame of the previous clip. 

R Neil Haugen
R Neil Haugen
Legend
December 30, 2024

Does the ECP show any keyframing of Lumetri? I'd be curious to see a screengrab of your ECP showing the right-side panel for keyframes ... and the left side listing of effects in use.

Everyone's mileage always varies ...
Fernando_silva
Fernando_silva
Participant
September 29, 2020

Hi, Have you solved your problem? I'm on a mac with PP CC 13.1.5 and it's happening also to me, and no matter if I render sequence in to out or export it, the problem subsists.

vincenzod41684742
vincenzod41684742
Participant
May 16, 2022

same problem today not corrected with rendering

R Neil Haugen
R Neil Haugen
Legend
May 16, 2022

So just the last frame doesn't have the correction?

 

Is this a section from a sequence with mulitple clips by any chance?

 

Neil

Everyone's mileage always varies ...
J
jacojestjak
Participant
May 21, 2019

Hi,

had the same issue just few minutes ago. I rendered whole sequence and everything seems to look fine, even the last frames that were previously untouched by Lumetri Color applied on adjustment layers above them. Just render your sequence in to out. Hope it works for you.

Fernando_silva
Fernando_silva
Participant
September 29, 2020

Hi, did the problem disappear to you? render sequencein to out doesn't solve it. Thanks

R Neil Haugen
R Neil Haugen
Legend
March 7, 2019

Huh ... never seen this behavior  ...

Neil

Everyone's mileage always varies ...
Terms & ConditionsAccessibility statement
Using the community Terms of use Privacy Cookie preferences Do not sell or share my personal information ad choicesAdChoices