Skip to main content
Participant
Oct 20, 2026 5:39 PM UTC
Answered

How to remove cropping from oversized video or photo when using "overshoot" on transitions?

In Adobe Premiere, there are a lot of beautiful transitions. Some, like “Slide”, will slide my footage into the scene exactly where I need it. Great.

If I choose an animation setting with “Overshoot”, the Slide effect will come in farther than intended, and then settle back into position. this is what I want. However, the Slide effect will also crop the footage so that you can see an obvious edge, even if the original footage is larger than the final video’s resolution. Changing the footage’s position does nothing to remove the crop that the transition provides, and if I remove the transition, the cropping effect goes away.

Is there any way to remove this? I love the Overshoot bounciness, but not the cropping.

    PaulMurphyCorrect answer
    Community Expert
    Oct 22, 2026 4:03 AM UTC
    1. Select the clips with the Slide transition, then choose Clip > Nest.
    2. Double-click the nested sequence to open it in the Timeline.
    3. Choose Sequence > Sequence Settings, then increase the Frame Size until it is large enough to show the edges of the clips in the main sequence when the transition overshoots.

    3 replies

    PaulMurphyCommunity ExpertCorrect answer
    Community Expert
    Oct 22, 2026 4:03 AM UTC
    1. Select the clips with the Slide transition, then choose Clip > Nest.
    2. Double-click the nested sequence to open it in the Timeline.
    3. Choose Sequence > Sequence Settings, then increase the Frame Size until it is large enough to show the edges of the clips in the main sequence when the transition overshoots.
    Translate
    CORCTON34033231
    Community Expert
    Community Expert
    Oct 21, 2026 12:08 PM UTC

    Hi Screenhog, a workaround that keeps the Overshoot bounce is to build the move yourself with Position keyframes instead of using the Slide transition:

     

    1. Remove the Slide transition from the clip.

    2. Select the clip and open Effect Controls > Motion > Position.

    3. At the start of the move, add a Position keyframe with the clip just out of frame on the side it slides in from.

    4. A few frames before the end of the move, add a second keyframe with Position a little past the clip's final resting position — this is your overshoot.

    5. At the end of the move, add the final keyframe at the exact resting Position, and adjust the keyframe spacing to get the bounce speed you like.

     

    Because you are moving the whole oversized clip itself, the part outside the frame is real footage rather than the transition's crop — just keep the overshoot distance smaller than the extra margin of footage you have on that side, so no edge shows.

     

    Hope this helps!

    Translate
    ScreenhogAuthor
    Participant
    Oct 22, 2026 7:06 PM UTC

    Your answer is good, and what I was frequently doing. But I still wanted to know if there was a solution that would use the transition.

    Translate