Make Subsequence became Simplify Sequence ??

Question

For record, I always edit Multicamera using Make Subsequence then import them into timeline and enable "Multi-Camera".
 
But problems happens or I clicking something by my fault (idk).

Now, the sequence shows only "Simplify Sequence" and I can't open it up to color grade.
I've tried to Simplify setting to make it be a Simplify Sequence

But within new sequence nolonger effects my Multicamera sequence :(. Sadly.
 
Hopefully someone help me with this!
Best.
H.H
 
Moderator notes: A couple of changes were made to your post.

The FAQ label has been removed. Please avoid labeling troubleshooting posts with "FAQ." The label is for actual FAQs in the forum.
The How to label has been removed. Please do not label posts with "How to." The label is meant to refer to actual How To posts in the forum.

Adobe Staff and Adobe Experts are the people meant to use those labels. I apologize if this issue was unclear. Thank you.

Ann Bens · Accepted Answer

Try ctrl+double click.

R Neil Haugen · Answer

Double click that Multicam and it will open in the Source monitor.

If you apply effects to clips in a bin they apply to every instance of any part of that clip anywhere in the Project. So doing a quick grab of the clips used to a sequence, matching them, then copying each clip's Lumetri and either dropping it on clips in the bin or the Source tab of the ECP means your whole Multicam is graded.

Sign up

To post, reply, or follow discussions, please sign in with your Adobe ID.

Sign in to Adobe Community

To post, reply, or follow discussions, please sign in with your Adobe ID.

Scanning file for viruses.

This file cannot be downloaded