Picture in Picture Switch Between Two Sources

Forum|Forum|5 years ago
September 21, 2020
2 replies
748 views

I have a talking head video and a series of images. The presenter runs through the entire video and the images change every ten seconds or so. I want both to be on the screen at the same time. When the presenter introduces an image, that image is up for ten seconds while the presenter is down in a corner. After the ten seconds, the active image moves to the corner and the presenter comes back full-screen. I know how to make a picture-in-picture, but how can I simplify the process of swapping the positions?

This topic has been closed for replies.

S

Speling_ChampAuthor

Participant

What I am trying to is always have one track full-screen and always have one PiP.

V1 starts full screen; V2 starts PiP

Then they switch, with V2 full and V1 PiP. The trick is that V1 is one long talking head clip. V2 is a series of images.

S

Sean356653573sbb

Participant

Did you figure this one out? I have a similar need. I have two angles of the same scene that I want to show PiP, but swap positions at some point before the two people meet up on one frame.

Peru Bob

Community Expert

Just create a track for each scenario.

Then cut each track where needed or keyframe the opacity.

R

RobShultz

Community Expert

You may want to create position keyframes for when you want them to change. After you Crete the keyframes highlight them, right click on one of them and choose interpolation/hold. Hold keyframes will hold them in place until the timeline indicator hits another keyframe.

Sign up

To post, reply, or follow discussions, please sign in with your Adobe ID.

Sign in to Adobe Community

To post, reply, or follow discussions, please sign in with your Adobe ID.

Scanning file for viruses.

This file cannot be downloaded