Skip to main content
wøøfie
wøøfie
Inspiring
April 7, 2024
Answered

Reconnect video to linked audio in sequence?

  • April 7, 2024
  • 1 reply
  • 454 views

I did a dumb. I worked through a couple hours of footage by selecting clips from source and inserting into the sequence. I never happened to notice that I didn't have a video track targeted, so now my sequence is full of audio-only clips.

 

Is there a clever way to reconnect the linked video to each audio clip, or am I doing this all over again?

Correct answer wøøfie

I figured it out:

 

  1. Make sure video and audio tracks are targeted correctly 😉
  2. Move the playhead to the very beginning of the sequence
  3. Select the first audio clip in the sequence
  4. Press F (Source monitor loads the appropriate footage with the original in / out selection loaded)
  5. Press overwrite (sequence gets updated with both video & audio using your original in / out selection)
  6. Select the sequence pane
  7. Select the next audio clip that needs video
  8. Repeat steps 4-7

1 reply

wøøfie
wøøfieAuthorCorrect answer
Inspiring
April 7, 2024

I figured it out:

 

  1. Make sure video and audio tracks are targeted correctly 😉
  2. Move the playhead to the very beginning of the sequence
  3. Select the first audio clip in the sequence
  4. Press F (Source monitor loads the appropriate footage with the original in / out selection loaded)
  5. Press overwrite (sequence gets updated with both video & audio using your original in / out selection)
  6. Select the sequence pane
  7. Select the next audio clip that needs video
  8. Repeat steps 4-7
3
30072824tla4
Participant
June 12, 2025

You just saved me hours of work, thank you. 

 

Terms & ConditionsAccessibility statement
Using the community Terms of use Privacy Cookie preferences Do not sell or share my personal information ad choicesAdChoices