Skip to main content
P
pix editor
Inspiring
October 18, 2020
Answered

Sequence Settings issue

  • October 18, 2020
  • 1 reply
  • 383 views

So I am trying to use warp stabilizer in my edit but it is displaying: "Warp Stabilizer requires clip dimensions to match sequence, fix by nesting. So I went on youtube to see what to do, and it said to right click the clip and check the properties. I did and it said the frame size is 1920 x 1080. I checked my sequence settings and that is what it shows. Now I am confused on what to do because next to the frame size, it says in light gray 160:90, which is not the same as 1920 x 1080... Here is an image of the Sequence settings and the properties of the clip I would like to apply warp stabilizer on:

 

This topic has been closed for replies.
Correct answer pix editor

I experimented a bit more and here is the simple solution:

 

go to Sequence >> Sequence Settings

 

Then go to the Pixel Aspect ratio which is under the Frame Size. Set this to square pixels.

1 reply

P
pix editorAuthorCorrect answer
Inspiring
October 19, 2020

I experimented a bit more and here is the simple solution:

 

go to Sequence >> Sequence Settings

 

Then go to the Pixel Aspect ratio which is under the Frame Size. Set this to square pixels.

Terms & ConditionsAccessibility statement
Using the community Terms of use Privacy Cookie preferences Do not sell or share my personal information ad choicesAdChoices