Hi, I know that there is a normalizer effects to change the volume peaks of the audio of a video. However, lets say I have video with an audio that has different volumes all throughout the video. Is it possible to make it so that the entire video has an equal volume? Thank you for the help!
Dynamic effect
do this to get your result
if you want to understand what's going on, read this to be more familiar
The Dynamics effect provides a set of controls that can be combined or used independently to adjust audio. Use either the graphical controls in the Custom Setup view, or adjust values in the Individual Parameters view. This effect is available for 5.1, stereo, or mono clips.
AutoGate
Cuts off a signal when the level falls below the specified threshold. Use this control to remove unwanted background signals in recordings, such as a background signal in a voice-over. Set the gate to close whenever the speaker stops, thereby removing all other sounds. The LED display colors indicate the gate’s mode: open (green), attack or release (yellow), and closed (red). Use the following controls for Gate:
Threshold
Specifies the level (between –60 and 0 dB) that the incoming signal must exceed to open the gate. If the signal level falls below this level, the gate closes, muting the incoming signal.
Release
Sets the time (between 50 and 500 milliseconds) the gate takes to close after the signal level has fallen below the threshold.
Hold
Specifies the time (between 0.1 and 1000 milliseconds) the gate stays open after the level has fallen below the threshold.
Compressor
Balances the dynamic range to create a consistent level throughout the duration of the clip by increasing the level of soft sounds and decreasing the level of loud sounds. Use the following controls for Compressor:
Threshold
Sets the level (between –60 and 0 dB) that the signal must exceed to invoke compression. Levels that fall below the threshold are unaffected.
Ratio
Sets the ratio by which compression is applied, up to 8:1. For example, if the ratio is 5:1, and the input level increases by 5 dB, the output increases by only 1 dB.
Attack
Sets the time (between 0.1 and 100 milliseconds) that the compressor takes to respond to a signal that exceeds the threshold.
Release
Specifies the time (between 10 and 500 milliseconds) it takes for the gain to return to the original level when the signal falls below the threshold.
Make Up
Adjusts the compressor’s output level (between –6 and 0 dB) to account for loss in gain caused by compression.
Expander
Reduces all signals below the specified threshold to the set ratio. The result is similar to the gate control but is more subtle. Use the following controls with Expander:
Threshold
Specifies a level in which the signal must fall to activate the expander. Levels that exceed the threshold are unaffected.
Ratio
Sets the rate at which signals are expanded, up to 5:1. For example, if the ratio is 5:1, a level decrease of 1 dB is expanded by 5 dB, resulting in a much faster decrease of the signal.
Limiter
Reduces clipping in audio clips that contain peaks in the signal. For example, by leveling out peaks that exceed 0 dB in an audio file, the overall level of the audio doesn’t have to be reduced below 0 dB to avoid clipping. Use the following controls with Limiter:
Threshold
Specifies the maximum level of the signal, between –12 and 0 dB. All signals that exceed the threshold are reduced to the same level as the threshold.
Release
Specifies the time (between 10 and 500 milliseconds) required for the gain to return to the normal level after a clip occurs.
SoftClip
Reduces clipping similar to Limiter but doesn’t use hard limiting. This control adds an edge to some signals to better define them within an overall mix.
or this link
Audio effects and transitions in Adobe Premiere Pro
Muhannad,
Already have an account? Login
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
AdChoices