Skip to main content
laura358
Known Participant
Oct 16, 2015 8:24 AM UTC
Answered

Can't generate TOC in WebHelp. My linked FrameMaker doc and TOC in RoboHelp look OK, though

Hello,

I am trying to generate WebHelp for the first time. I linked a FrameMaker book to a project in RoboHelp and auto-created a TOC, which looks OK in RoboHelp

Then I right click on WebHelp (Primary Layout) and generate with the default skin and default TOC.

However, then there's no Contents in my output:

Also, only the first page "Introduction" is there, none of the rest.

FrameMaker 11, RoboHelp 10, Technical Communication Suite 3

Any suggestions?

Thanks,

Laura

This topic is closed to new replies. Start a new post to keep the conversation going.
Jeff_Coatsworth
Jeff_CoatsworthCorrect answer
Community Expert
Oct 16, 2015 1:09 PM UTC

Make sure you’re all patched up with the fixes for browser security changes (see Willam’s site wvanweelden.eu) I suspect that’s what’s interfering with seeing the TOC. BTW, you know that you could have used your FM TOC as the RH one if you had told the Conversion Settings to use it (your FM IX file too if you wanted also)

View reply

2 replies

Jeff_Coatsworth
Community Expert
Jeff_CoatsworthCommunity ExpertCorrect answer
Community Expert
Oct 16, 2015 1:09 PM UTC

Make sure you’re all patched up with the fixes for browser security changes (see Willam’s site wvanweelden.eu) I suspect that’s what’s interfering with seeing the TOC. BTW, you know that you could have used your FM TOC as the RH one if you had told the Conversion Settings to use it (your FM IX file too if you wanted also)

Translate
laura358Author
Known Participant
Oct 19, 2015 12:16 PM UTC

Updating did resolve my issue. And thanks for the TOC tip - it looks much better already.

Thanks for your help.

Best regards,

Laura

Translate
Terms & ConditionsAccessibility statement
Using the community Terms of use Privacy Cookie preferences Do not sell or share my personal information ad choicesAdChoices