Skip to main content
Inspiring
Jun 15, 2007 1:23 AM UTC
Question

RH6 Crashes

Installed RH6 on workstation. Installed source control on a new server, migrated the files of all projects, opened my project from source control. So far, so good, everything appears to be working as usual. So I attempted to generate WebHelp Pro. The process starts quickly enough, but at about the halfway mark of "copying files", it slows right down. AFter about 5 minutes, it then commences "generating WebHelp Pro". It's very slow and at about the halfway mark it crashes. I re-installed RH6, same thing. Deleted XPJ and CPD, and tried again.
No dice, same failure.
This project has been working fine for RH x5. The same problem occurs on colleague's machine.
I am desperate! Has anyone had this problem? If I have a corrupt file in the project, is there a way of isolating it? It is a large project, 112Mb, about 3,000 files.
    This topic is closed to new replies. Start a new post to keep the conversation going.

    14 replies

    Inspiring
    Jun 17, 2007 9:58 PM UTC
    Thanks Peter. I have been a member of this forum for many years, but seldom post as I have a lot of experience with RHelp, RServer/Engine and RSource. I am system admin for the RHelp servers and the source control server. I have admin rights to the workstations for installation. I use Build Expressions quite a bit and have many tables with merged cells, so I will check this snippet and get back to the forum with my results.
    BTW, I had radically customised a skin for WHelpPro to fit in with the corp[orate design, I had done some JavaScript edits to do this so I am trying to generate my project using a generic skin (XPBlue). So far, it seems loike this is NOT the problem, so I'll persevere.
    Translate
    Peter Grainge
    Community Expert
    Community Expert
    Jun 15, 2007 6:09 AM UTC
    Welcome to the forum.

    I was inclined to ask if you have installed RoboHelp Server 6, which is not the same thing as the server side of source control. It is the equivalent of RoboEngine which you would have used to generate a WebHelp Pro output from X5. If you don't have those components, you should be generating WebHelp, not the Pro output.

    However, your topic summary also mentions CHM output giving a problem. Is it the same problem?

    Two possibilities. One is that you did not have admin rights attached to your logins when you installed RH. The other is that you have some tables in your source files with merged cells in the extreme right column and you are using a build expression.

    For the first, there is a topic on my site that explains about installing RoboHelp.

    For the second, look at Snippet 68. There is a patch that resolves that one.

    Let us know how you resolve it or post back if it is none of the above.

    Translate
    Use the menu (bottom right) to mark the Best Answer or Highlight particularly useful replies. Found the answer elsewhere? Share it here.