square tip stroke effect in AE

XeonNetwork  wrote ... Though I don't know how accepted the answer on this and I don't think I'm using a shape layer. I'm trying to make this Smooth Text Animation in After Effects - After Effects Tutorial - Writing and Masking - YouTube but with a blocky font instead of cursive

That's an awful tutorial. Inefficient and it leaves out a lot of critical steps. The only thing that tutorial demonstrates is a way to kind of sorta get a write on effect to look kind of ok if you don't look very close and you don't care much about your final product. Even setting up the original type layers was poorly demonstrated and did not use tools available that make alignment and positioning both accurate and simple. You have to vet your trainers. Make sure they know what they are talking about.

The easy way to create a text write on animation is to:

1. Create and position all of the text you want to reveal on a single layer
2. Add a shape layer with a stroke only and draw a path through the center of the characters using the minimum number of points possible to write over the text that follows the same path you would follow when using a pen but not lifting it off the paper
3. Make sure that the stroke on the shape layer path completely covers all of the characters
4. Add Trim Paths to the Shape layer and animate the range selector to make the line start at the first character and end at the last
5. Put the Trim Paths layer above the text layer and set it as a track matte
6. Find any place that parts of the letters are revealed before they should be because the stroke is too wide at that point and fix those problems with a mask with animated opacity or by adjusting the path a little bit
7. Fine-tune the speed of the write on to make it appear natural. It is often very handy to shoot some video, even if it is just with your phone, of you writing out the words and temporarily drop that video in your comp to use as a timing guide

That's it. You have a lot more control, there are fewer steps to get you to the almost perfect look and it is possible to write on with either a square end or with a round one. If you use the new Create Nulls from Paths script, you can even have a null follow that path then parent any brush stroke you like to the motion path and make it look like the text was drawn on by any kind of brush or pen you want to use. The final comp would look like this if all you wanted was a square end:

A single shape layer path with very few points accurately positioned and following the same path as someone would follow to write the text on + trim paths + track matte. It took me less than 5 minutes to set up this comp and make it work perfectly.

Here's a project file for you to play with. Dropbox - Write On News.aep

(note: if the browser adds a .txt extension to the file when it is downloaded just delete it)

How do I install it and how do I use it. Sorry for the late reply.