Skip to main content
R
Rick0725
Inspiring
September 6, 2018
Answered

How to set up Stereo upmixing to 5.1 software in audition

  • September 6, 2018
  • 1 reply
  • 6646 views

Please help setting up a stereo up mixing VST plugin Penteo composer 5 in Audition. 2 channel stereo to 6 discrete channels.

I saw overviews all over the internet but not specific setup instructions. Will it even work as a plugin in ?.

Thanks

Rick

    This topic has been closed for replies.
    Correct answer Rick0725

    Rick0725  wrote

    Therefore outputting what is coming out of the DAW to monitor will not work connected to the surround amp.

    Unless the surround amp has discrete 6 analogue inputs.

    Rick0725  wrote

    And what do I use for the test signal to calibrate levels to the speakers out of the DAW.

    Pink noise and a sound level meter.

    Rick0725  wrote

    I have a few velodyne powered subs with line input. will that work.

    One of those would work for the LFE. But you would need normal full range matching speakers for the centre and surround speakers to be similar to your main stereo pair.


    Final word.

    The studio set up is complete. 5 JBL studio monitors, Sub, Focusrite 18i20 audio interface, software, Dolby encoder, etc.

    Penteo works in audition CC 2018. Create a simple 5.1  multitrack session. Track 1 is the stereo audio and the Penteo plug in is added as an effect on the master. Tweak the penteo settings and export the 5.1 multitrack mixdown. Scan the 5.1 audio, make volume adjustments if necessary to the individual channels, determine the Dialogue Normalization setting, encode the dolby in media encoder with surcode, listen to the outcome, make corrections and encode again if necessary, and done.

    1 reply

    SteveG_AudioMasters_
    Community Expert
    SteveG_AudioMasters_Community Expert
    Community Expert
    September 6, 2018

    The makers of this plugin have provided absolutely no idea of how to route it - not helpful. In the top right-hand corner of all plugins when run in an Audition carrier is a little symbol with a line joining a source to one of three dots (next to the i button) and clicking on this will give you the routing options. The issue is that you are having to start with a stereo file and end up with a multi-channel one, and I'm not sure how that will work exactly, as I've only ever done it the other way around - converted B format to stereo. I will check to see if it's possible to output a surround file from that plugin (potentially it can) and that might give a bit of a clue as to what you'll need to do...

    R
    Rick0725Author
    Inspiring
    September 6, 2018

    This is the response I got from the company.

    Those settings are specific to your VST host not the plugin  - if you look up your DAW host
    settings, that should give you the information you need.

    I am guessing that the software outputs 6 mono files

    Rick

    R
    Rick0725Author
    Inspiring
    September 11, 2018

    I can not get the Penteo plugin to work in audition with the 18i20. The plugin is only mapping 2 channels. I can not figure it out. any suggestions?


    Think I got the plugin to work in a 5.1 multitrack session.

    Track 1 is the stereo track. Added the plugin to the master track and exported 5.1. mapped fine. pretty slick.

    now the next challenge is to monitor the 6 channels. The multichannel input attempt did not work. no sound came out. could I have done something wrong in the amp set up. the multi channel in the amp is pcm .

    Terms & ConditionsAccessibility statement
    Using the community Terms of use Privacy Cookie preferences Do not sell or share my personal information ad choicesAdChoices