Improvement of the new BEVEL

[SerQQ]

Hello, I already wrote inside another post, but no one responded, so I decided to write in a separate one

Thank you very much for updating the Bevel node, it is really important for me!

I also want to ask you about small fixes of Bevel Smooth node.

1. Make a third output for exporting the general mask (after smoothing and offset mask)
2. Add the ability to make the background white, in the "Direction/In" mode
3. In the "Maximum Distance" parameter, for me personally it would be very important to have a divider or change the Steps of parameter change. Since I often use values ​​like 0.003, which have to be entered manually. Since the minimum step on the slider is 0.01

[Luca Giarrizzo]

Hello,

Thank you for your feedback. Indeed, I did not reply in your original reply in this thread and apologize for that.

Your suggestions were shared with the author of the Bevel Smooth node, and the node will be updated with your suggestions in mind. I appreciate your patience in the meantime!

Best regards.

[SerQQ]

Thank you, I hope my words won't go unnoticed

[SerQQ]

I added a third point which is very important for me, for some reason I didn't write about it before. About changing the slider step or adding a separate "Divider" for it.

I am a real fan of this node and I want it to be good 

[Luca Giarrizzo]

Hello @SerQQ,

Thank you for your patience. I have added your third request to the list of requested adjustments for the author of the Bevel Smooth node.

Best regards.