Change width of panel?

[sebastian2012a]

Hi,

Is there any way to change the width of the panel so it's possible to read the tab titles?

Thank you in advance!

[Monika Gause]

Just grab it on the left and make it wider.

[sebastian2012a]

Hi, thank you! I thought it should work that way, but it doesn't, except for two tabs: Color and Brushes. When either of these two tabs are active, the cursor turns into a double-arrow as expected when I hover above the edge.

But as soon as I switch to any other tab, the panel is super narrow again -- and the double-arrow is gone.

EDIT: As a workaround, I can switch back to the Color tab -- which stays wide permanently after adjusting it -- and from there click the desired tab (which is then visible because the Color tab is wide). So, that's workable...

[Ton Frederiks]

When it works, can you save it as a Workspace?

[sebastian2012a]

Thank you -- I saved a Workspace while the Color tab was active and the panel's size adjustable, but again; as soon as I switch to another tab, it's no longer possible to adjust width (or height, for that matter).

But had it not been for Monika's reply, I wouldn't have experimented long enough to see that Color and Brushes tabs can in fact be adjusted.

So, I can easily get used to switch to the Color tab when I need to see all tabs at once...

[Kurt Gold · Accepted solution]

Basically, only panels that have 10 horizontally arranged bombs at the veriest bottom of the panel can be resized.

[sebastian2012a]

Ah thank you -- that explains it!