Copy link to clipboard
Copied
In producing a book to be saddle stitched, as sheets are folded and assembled in signatures the position of the page shifts gradually as pages progress, due to the folded thickness of the paper. How is this normally compensated for to ensure the position of the content of each page remains consistent throughout the book? Does the printer normally fine tune positioning at press time or is this done at the design stage? I'm working on a simple photo book where all images are the same size and center positioned on each page, and want the position to remain precise and consistent throughout. Printing on 150g paper.
Thanks for any advice!
It's called "creep" - but don't worry - it's done by the printer - using Imposition Software.
They will take care of it.
The only inconsistencies can be due to the folding and cutting misalignment.
In my experience this issue known in the industry as "creep" is handled by the printer. However, it is still always a good idea to speak to your printer at an early stage in your designing to confirm exactly what they will require from you for the job.
Does the printer normally fine tune positioning at press time or is this done at the design stage?
Hi @TC5 , Also, creep is always handled by the printer’s imposition software, so you should not attempt to make an adjustment in the layout. InDesign’s Print Booklet provides rudimentary imposition for making in-house dummies, and has a Creep setting.
And keep in mind that binding and trimming is never perfect—that’s why you need to include a bleed (typically .125") with objects that cross
...Copy link to clipboard
Copied
It's called "creep" - but don't worry - it's done by the printer - using Imposition Software.
They will take care of it.
The only inconsistencies can be due to the folding and cutting misalignment.
Copy link to clipboard
Copied
In my experience this issue known in the industry as "creep" is handled by the printer. However, it is still always a good idea to speak to your printer at an early stage in your designing to confirm exactly what they will require from you for the job.
Copy link to clipboard
Copied
Thanks both for clarifying.
Copy link to clipboard
Copied
Does the printer normally fine tune positioning at press time or is this done at the design stage?
Hi @TC5 , Also, creep is always handled by the printer’s imposition software, so you should not attempt to make an adjustment in the layout. InDesign’s Print Booklet provides rudimentary imposition for making in-house dummies, and has a Creep setting.
And keep in mind that binding and trimming is never perfect—that’s why you need to include a bleed (typically .125") with objects that cross the trim—so be prepared for some imprecision.
Copy link to clipboard
Copied
thanks rob for the details.