Monitor Calibration Issue - iMac 5k Late 2015

Forum|Forum|9 years ago
March 6, 2017
2 replies
13722 views

Hello,

i am using the i1 Display Pro to calibrate and i have noticed that when i compare my old profile to the new one, the new one has a grey/greenish tinge.. does anyone have a guide to properly calibrate an iMac 5k with the i1 Display Pro?

Thank you

This topic has been closed for replies.

Correct answer D Fosse

That looks like a good and comprehensive guide.

I'd just like to add that if this is one of the new DCI-P3 panels (Apple's variety of wide gamut), it's possible that it uses "GBr LED" backlighting, not "White LED", and the software should be set accordingly. This will affect the measured white point.

Most traditional wide gamut panels use GBr LED.

Generally, the calibration targets should be set to match the paper/final output (not the other way round). The numbers aren't important, D65 or otherwise. Let the numbers fall wherever they want. Just get that monitor white=paper white match.

Temperature is just half the story. That's just the yellow/blue axis. There's also a green/magenta axis to consider, and if this can be adjusted do so.

D Fosse

Correct answer

Community Expert

That looks like a good and comprehensive guide.

I'd just like to add that if this is one of the new DCI-P3 panels (Apple's variety of wide gamut), it's possible that it uses "GBr LED" backlighting, not "White LED", and the software should be set accordingly. This will affect the measured white point.

Most traditional wide gamut panels use GBr LED.

Generally, the calibration targets should be set to match the paper/final output (not the other way round). The numbers aren't important, D65 or otherwise. Let the numbers fall wherever they want. Just get that monitor white=paper white match.

Temperature is just half the story. That's just the yellow/blue axis. There's also a green/magenta axis to consider, and if this can be adjusted do so.

mickspawnAuthor

Inspiring

Hello, GB-LED is indeed selected (cant see GBr LED) and i still have the weird look. Could it be the lighting in the room that affects the profile too and how it is made? i have changed lighting setup.. my old profile from my old light setup displays true whites, but the new profile i made with the new lighting setup shows a grey/green tinge.

trshaner do you mean instead of GB-LED try selecting RGB-LED?

when i calibrate the brightness.. i set it for 120 and my display either does 113 or 142.. should i be selecting 120 instead of 142? doesnt seem bright enough lol

how do i get the white=paper match?

mickspawnAuthor

Inspiring

in addition: im using GB-LED, 120cdm, D65, tone response curve - Standard, Gamma - 2.20, contrast ratio - Native, Chromatic Adaptation - Bradford, ICC Profile Version - Version 2, Profile Type - Matrix based, Patch set size - Small, Adjust Brightness, contrast and RGB gains - Manual

these are the only settings i see available.