Skip to main content
Nitehawkhp
Nitehawkhp
Participant
May 11, 2019
Answered

Old 1940's negatives. How can I print a picture from them?

  • May 11, 2019
  • 2 replies
  • 1144 views

Greetings,

My wife has some negatives from the 1940's that we would like to print pictures from. I have done a little research on the subject and was successful in scanning the negatives and doing some minor touch up. However, when I invert the negative it appears all washed out and the dark suit her father is wearing is covered with white flecks all over it.I don't know enough about FSE 2019 to fix that volume of editing. Can someone offer suggestions on how to proceed?

Thanks in advance anyone can offer me.

Regards,

Rod

    This topic has been closed for replies.
    Correct answer 99jon

    Hi Rod

    You could try camera raw sliders

    File >> Open in camera raw

    Select a batch of similar looking photos

    On the left side of the dialog click the select all button and the settings will be applied to the whole batch simultaneously.

    Experiment with the sliders in the basic tab but don’t push the black slider too far left as you will darken the overall image and may need to increase exposure.

    Then go to the detail tab – see image below or click to enlarge – and try noise reduction. The luminance slider often reduces grain and gives a softer look.

    When finished click the button bottom right “Open Images” and that will send them into the regular Editor where you can re-save.

    2 replies

    Nitehawkhp
    NitehawkhpAuthor
    Participant
    May 11, 2019

    Thanks to everyone that has answered my question. I was able to edit the negatives and the pictures turned out fantastic and we are pleased with the results.

    99jon
    99jonCorrect answer
    Legend
    May 11, 2019

    Hi Rod

    You could try camera raw sliders

    File >> Open in camera raw

    Select a batch of similar looking photos

    On the left side of the dialog click the select all button and the settings will be applied to the whole batch simultaneously.

    Experiment with the sliders in the basic tab but don’t push the black slider too far left as you will darken the overall image and may need to increase exposure.

    Then go to the detail tab – see image below or click to enlarge – and try noise reduction. The luminance slider often reduces grain and gives a softer look.

    When finished click the button bottom right “Open Images” and that will send them into the regular Editor where you can re-save.

    Terms & ConditionsAccessibility statement
    Using the community Terms of use Privacy Cookie preferences Do not sell or share my personal information ad choicesAdChoices