Having issues with Audio Channels in new Premiere Update (v25)

Forum|Forum|1 year ago
October 28, 2024
7 replies
5829 views

A1 only plays from the left, A2 only plays from the right, can't hear anything from A3 and A4 channels, and then A5 the audio is played from both ends, so A5 works properly. This was never issue, then I updated to v25. Never changed the sequence settings or anything of the sort.

It's really weird that the exact same audio is played differently on the same sequence. The audio channel seems to be the issue here.

Sound

Correct answer Richard M Knight

You have your sequence setup as a 4 channel multitrack. Tracks 3 and 4 are going to outputs 3 and 4 which is why you are not hearing anything. You also have tracks 1 and 2 panned hard left and right.. Start a new stereo sequence and copy and paste your footage to the new sequence, If needed pan your tracks to the centre.

S

Smamed67

Participant

Hey so trying all of these solutions can confirm none of them worked for me. 4 channels continued to appear in audio under adobe settings: audio, and no amount of adjusting it under sequence settings or audio settings did anything. The ONLY thing that worked on v25 on a macbook running osx sierra, was to manually change the number at the bottom of each audio channel, for every sequence, to zero. Some were set at 100 and some at -100--- nothing that I did explains this, and my audio had two matching left right stereo channels.

D

David36154566bxej

Participant

Just to say you're not alone I also had this issue today - and the solution below fixed it. Thanks all

B

BrianPail

Participant

when creating sequence you need to go to TRACKS and set it as on the picture I added.

It worked for me so I hope it will fork for you too

J

jimmy2cans

Known Participant

I had the same problem. Didn't realize there was a tracks tab when creating a new sequence. I actually like the new feature bc it gave more control w/o have to go into audio channels. So this set up works. Just wish I didn't have to make a new sequence to apply stereo. Wish the tab was in Sequence Settings as well.

R

Richard M Knight

Correct answer

Community Expert

You have your sequence setup as a 4 channel multitrack. Tracks 3 and 4 are going to outputs 3 and 4 which is why you are not hearing anything. You also have tracks 1 and 2 panned hard left and right.. Start a new stereo sequence and copy and paste your footage to the new sequence, If needed pan your tracks to the centre.