Skip to main content
A
Andrew5E2D
Participant
April 3, 2021
Answered

Push, Slide, Cube transition A and B clips get swapped?

  • April 3, 2021
  • 1 reply
  • 993 views

Hi Everbody,
I have a problem in premiere pro when I try to add transition between two clips. The problem is that in the beginning of the transition there's only the "A"clips presents on both side of the transition, in the  middle both "A" and "B" clips are where they should be, but at the end both side of the transition will only show the "B" clips.
I attached screenshots that help with the explanation.
I googled it, and search here in the forum, but didn't seem to find any mention of this problem.
This occur if I use a push-slide-or cube transition, so basically in those cases where the "B" clip should come into the frame and push the "A" clip out of it.

Any help is much appreciated.

This topic has been closed for replies.
Correct answer Ann Bens

The clips are in the same base video / sequence i just want to make the cut into a transition. So i think they have sufficient handles.


If you have a clip and cut it in the middle and dont trim back the edges left and right of the cut the transition does not work properly.

https://helpx.adobe.com/premiere-pro/user-guide.html/premiere-pro/using/transition-overview-applying-transitions.ug.html

 

1 reply

Ann Bens
Community Expert
Ann BensCommunity Expert
Community Expert
April 3, 2021

A
Andrew5E2DAuthor
Participant
April 3, 2021

Yes I know that. My problem is that at the first third time intervall of the transition only frames from the A clip are visible , and on the last third time intervall only frames from the B clip are visible, whereas if it would work properly frames from both A and B clips should be visible until the end of the transition.
So in the picture that I attached the B clip should appear on the left side and push A clip out of the frame. However in the beginning another version of A clip appears instead of the B clip, and it's the same problem in the end only in reverse.

Ann Bens
Community Expert
Ann BensCommunity ExpertCorrect answer
Community Expert
April 3, 2021

The clips are in the same base video / sequence i just want to make the cut into a transition. So i think they have sufficient handles.


If you have a clip and cut it in the middle and dont trim back the edges left and right of the cut the transition does not work properly.

https://helpx.adobe.com/premiere-pro/user-guide.html/premiere-pro/using/transition-overview-applying-transitions.ug.html

 

Terms & ConditionsAccessibility statement
Using the community Terms of use Privacy Cookie preferences Do not sell or share my personal information ad choicesAdChoices