Skip to main content
Known Participant
May 31, 2006
공지사항

Acrobate professional and the 7.0.7 patch

I have set up the Acrobat Professional 7.0.0 upgrade install VIA the Install Tuner. We have managed to patch the Admin install to 7.0.5. When we try to run the 7.0.7 patch against the Admin install it starts and stops right away like something is wrong with the AcrobatUpd707_all_incr.exe patch file. Can anyone tell me if we are doing something wrong or is there in-fact something wrong with the 707 patch? We were successful in patching to 7.0.5 so we are following the same steps that worked with the 7.0.7 patch without any luck.

Thanks in advance for any help or suggestion you might be able to offer.

Ed Puariea
이 주제는 답변이 닫혔습니다.

26 답변

_Ed_Puariea_작성자
Known Participant
June 1, 2006
No error the install just stops and goes away about 5 seconds after it starts. Should we reboot or anything special after the 7.0.5 patch? See we were able to get it up to 7.0.5 so we think we are doing it right. There must be something were missing.
Participating Frequently
June 1, 2006
any error messages? I just ran throgh this routine and it worked fine.
_Ed_Puariea_작성자
Known Participant
June 1, 2006
msiexec /a <path to admin install>\acropro.msi /p acro707.msp
Participating Frequently
June 1, 2006
no, the patch is fine. what are you command line parameters?
_Ed_Puariea_작성자
Known Participant
June 1, 2006
Thanks for you reply.

We did extract the msp file from the .exe file and ran the patch on the admin install point. That is where it fails. It starts the update then just drops or closes. The 707 patch runs fine when applied to 705 pro when it is installed. We wanted to be able to patch the admin install to 7.0.7. We were able to patch the admin install from 7.0.0 to 7.0.5 but the 7.0.7 fails. We were thinking that the 7.0.7 patch had something wrong with it.

Ed
Participating Frequently
June 1, 2006
extract the msp file from the .exe file and run the patch on the admin install point.