I am trying to follow a couple different guides at making a looping turbulence displacement.

[GrumpaDwarf]

I am trying to follow a couple different guides at making a looping turbulence displacement. I am trying to add the loopout cycles command but I was not sure if i had to use keyframes with it to make it work. I have keyframes for the evolutions at the start and end of my layer. The first key frame I left at 0 and the last key frame I put in 200 rotations. The wave does fine until around 2:45 seconds or so when it stops. Please advise.

[Kevin-Monahan · Accepted solution]

Hi,

See if this post helps you.

Thanks,

Kevin

[GrumpaDwarf]

Finally got it to work. It sure is tempermental. So I don't set a value for evolutions at the start which was one of my mistakes. I left it alone this time and went straight to clicking the cycle box and followed out the post. I am now working on the values to speed up the movement a little but I now have 6 minutes of working ocean wave. Thanks