Copy link to clipboard
Copied
1. Setup a spot colour
2. Apply it to any object
3. Set your layer to no printing
4. Check the separations
I must admit - the first time I clicked the separations colour it was ok. But further clicking resulted in it breaking.
It shows the spot colour as CMYK.
Until you set the layer to Print again.
Do you reckon it's a bug or something else?
I've tested this on Mac and Windows.
Yes, it is confusing and one may call it a bug.
Interestingly, the issue does not occur if the non-printing layer is a sublayer inside a printing main layer.
But then I would not expect the spot color in the Separations Preview.
Let's call it a bug.
Copy link to clipboard
Copied
It does not seem to affect printing as separations or saving as PDF, but it is confusing
Copy link to clipboard
Copied
Yes, it is confusing and one may call it a bug.
Interestingly, the issue does not occur if the non-printing layer is a sublayer inside a printing main layer.
Copy link to clipboard
Copied
But then I would not expect the spot color in the Separations Preview.
Let's call it a bug.
Copy link to clipboard
Copied
Thanks for confirming - I'll file it as a bug in the morning.
Copy link to clipboard
Copied
Copy link to clipboard
Copied
Voted.