Svg not displaying properly in tinkercad

[estherb37908743]

sorry for sounding like a noob but I've been at this for 3days and everytime I've saved the svg it looks all wrong. It saves all three paths instead of 2 paths that I'm trying to save causing a hole and not displaying properly

[estherb37908743]

[Monika Gause]

You need to check this in Illustrator's layers panel.

Also: what exactly are you doing?

What exactly is this supposed to look like.

We can't read your mind, please tell us as much as possible.

[estherb37908743]

I am trying to save 3 different different svgs to extrude 3 different things in tinkercad but it all 3 come out as the first picture the same. i'm trying to make a cookie cutter as an edge, support, and cutedge. but the support comes out as a hole and all three svgs come out the same. i believe im doing something wrong but i'm Not sure it just won't save it saves it as all three parts no matter what i do

[estherb37908743]

instead of saving 2 paths like above it saves all four paths or the whole causing a hole in the middle when imported to tinkercad even though i hide the other 2 paths

[Monika Gause]

The layers panel shows 4 paths in your file.

Do you know how this is supposed to look like in order to work as expected in TinkerCAD? Because we can't know that.

At the moment it looks like there have been strokes applied to it in TinkerCAD and then extruded. But one of the strokes is just not fat enough. Do you know how 3D works are are you just dabbling around or following some vague tutorial?

[estherb37908743]

i just want to know how to save this svg into 3 separate parts into 3 separate svg filesive already tried hiding the layers i didnt need and it did not work just forget about tinkercad

[Monika Gause]

estherb37908743  schrieb

i just want to know how to save this svg into 3 separate parts into 3 separate svg filesive already tried hiding the layers i didnt need and it did not work just forget about tinkercad

Sorry, I really don't understand this sentence.

[nilk narf]

sorry to butt in but how do i post a topic here?

[estherb37908743]

Illustrator community forum > actions > discussion > start a discussion

[nilk narf]

thank you.

[shimbu]

I think that deleting objects which You don't need and then exporting to svg should do the job.