Sequence controls don't recognize the full sequence

[DragonPro55]

I added a clip to the end of my sequence, but the controls don't seem to recognize it. When I click on the Got to Out button, it takes me to the previous end of the sequence before I added the clip. Never had this happen before. How do I get it to take me to the new end of sequence?

[Averdahl · Accepted solution]

When I click on the Got to Out button, it takes me to the previous end of the sequence before I added the clip.

By @DragonPro55

You have an Out Point already set on the Timeline, so when you click on Go to Out Point it will go the the Out Point you have set there. This is expected.

Press Ctrl+Shift+O to clear the Out Point and then click Go to Out Point. (Or, do nothing and just press the End-key on your keyboard.)