Sequence Settings issue

[pix editor]

So I am trying to use warp stabilizer in my edit but it is displaying: "Warp Stabilizer requires clip dimensions to match sequence, fix by nesting. So I went on youtube to see what to do, and it said to right click the clip and check the properties. I did and it said the frame size is 1920 x 1080. I checked my sequence settings and that is what it shows. Now I am confused on what to do because next to the frame size, it says in light gray 160:90, which is not the same as 1920 x 1080... Here is an image of the Sequence settings and the properties of the clip I would like to apply warp stabilizer on:

[pix editor · Accepted solution]

I experimented a bit more and here is the simple solution:

go to Sequence >> Sequence Settings

Then go to the Pixel Aspect ratio which is under the Frame Size. Set this to square pixels.