Video pixelating after export - not showing while editing

[rcompton272]

Hello! 

After exporting there is a ton of pixelation in my video. However, I do not notice any when inside the program. I have it set to match source - highest bitrate and the source video was rendered in 60 fps. I've tried exporting through Media Coder and it did not seem to make a difference.

I did a google search, but I am at a beginner level and do not understand much outside of the basics of video editing. Any advice/instruction would be greatly appreciated!! 

Thanks 

[RobShultz]

Perhaps try checking Match Sequence Settings and see if you  have better results.

[R Neil Haugen · Accepted solution]

That 10Mbps target is quite low for UHD encoding. If you try the Adaptive High Bitrate, it jumps to about 126Mbps!

So bump that Mbps rating up. Probably 30-40 is about the minimum for UHD work. But it varies by person, media, and taste of course. And final use.

Neil

[rcompton272]

Thank you!! Mine went up to around 150Mbps and looked much better.