Mask not lining up to where i masked.

[Henry5D34]

Mask does not line up to where i masked, almost like it scales off the middle, help me!

[Sami Succar]

What version are you on?

[Henry5D34]

Version 14.5 .0

[Sami Succar · Accepted solution]

Do a quick test.

Drag the clip from the bin to the sequence icon, so you have a sequence with the exact settings of the clip.

Create an opacity mask in this new sequence, and check if it's also offsetting.

[Henry5D34]

There was a mistake on my half, the sequence and clip setttings were not the same!
But still same offset error.

[Sami Succar]

Are you applying the mask directly on the clip, with no other effects?

[Sami Succar]

Also try to nest the clip, and apply the opacity mask on the nest, see if it helps.

[Henry5D34]

Thanks Sami, I actually followed your first instruction better, I created a new sequence again, by right clicking, new sequence from clip.

I had the wrong sequence settings, Sorry, and Thanks for your help.

[Benni1214]

I have the exact same problem, and I created the sequence by dragging it to new item, so the sequence should match the source...