Reveal original source in and out points from clip in sequence

[lembasts]

I have a big source file and I marked a portion with in and out points and created a sequence from it. At this point I see the original sournce file in the source monitor and the in and out points used to create the clip in the sequence. I then continue on and do lots of other edits.

I now want to reveal the in and out points for that clip in the sequence. What I want to see is what I saw originally when I marked it. I want to see the big source file in the source window and the in and out points as they were marked when I created the clip. How do I reveal those please?

Thanks

David

[Ann Bens]

Double click on a clip in the timeline to open in Source Monitor.

[lembasts]

Thanks. That opens just that clip in the Source Monitor. I wondered if it could open the entire source file which shows the in and out points as it would have looked just prior to me adding that clip to the sequence?

[Ann Bens]

It opens the entire source clip in the SM with the in and out point for that clip.

it does not show you all in an outpoints.

[lembasts]

The sequence length is 3:17. WHen I double click on it the length of the clip in the source monitor is 3:17. What I was after is seeing the entire source clip in the source monitor (length over 2 hours) with the in and out points for that clip marked if possible.

[Suraj5EBF]

Hi David,

make "Sub sequence" from sequnce menu and drag that sequence to new project then only mark In Out part you have.

thanks,

Suraj Shinde.