Hi all! I'm creating a report that I'll be updating every few months with new data. So the length of each section will vary from report to report. Up until now, I've been updating both the page numbers and the table of contents by hand. But I'd like to automate the process. Here's how it's set up.... the first few pages are standard and are numbers 2, 3, 4, etc. We have them now as 2.0, 3.0 and 4.0. But then we get to the data. So page 5 (for example) is labeled as 5.0. If the data takes up more than one page,we go to 5.1, 5.2, 5.3, etc. But only page 5.0 shows up in the table of contents. I've got the table of contents working (automated), but I can't figure out how to get the page numbers in the Table of Contents and in the report to have the .0, .1, .2, etc. to show up in each place. How would I do this? And I have a second question about the table of contents formatting. I want the bold text on the left and the bold page number on the right... separated by a series of periods (I think these are called "dot leaders") created by a tab. But I want those dot leaders to be non-bolded. Is this possible? I'm not sure how to format a tab separately from the text on either side of it. Thanks! PS The example I'm attaching is very short compared to the real thing. If it was only these few pages, I'd just keep doing it by hand!).
... View more