Slip Tool Not Showing All Previews?

[ThioJoe]

How do I get the slip tool to show the little previews above the start/end preview boxes like in this support demo? 

When I do it I only see two. It's been like this as long as I can remember.

I always found the Slip Tool annoying to use because I didn't know it was supposed to have the previews above (for what I believe are the view at the playhead, which is usually what I care about seeing). Until I saw some tutorial that had them. 

Not sure if it's a problem with my configuration or what. I tried using the slip tool in a fresh installation on a new virtual machine and it still only shows the above.

[Ann Bens · Accepted solution]

To see both sides the clips needs a clip on the left side and on the right side.

Might want to uncheck Composite Preview in Trim Mode (wrench timeline).

[ThioJoe]

Ah ok thanks you're right, it shows the smaller top previews when there's clips on the left and/or right. 

I guess there isn't a way to have it show what I wanted, which would be a preview for the what the frame will be at the playhead, instead of previewing the new start/end frames.

A lot of times I'm adding B-Roll and want some particular part to sync up with a certain point in the timeline. I guess adding a marker to the clip is still the best way for that.