Warp Stabilisation creates jumping image (+ what are the best settings)

[johnl33044717]

1) When I use the Warp Stabiliation the image in my normal preview monitor jumps around like crazy. (Some screen shots below - note: I'm jusing 3 videos next to each other, image should be within the grey lines). 

When I export the video its fine - but for editing it would be very helpful for the image to also not jump around. Any ideas?

2) In general what are the best settings of the stabilisation effekt? (e.g. Footage of birds flying, kamera sometimes zooming and also turning)

[R Neil Haugen]

Settings for Warp will vary, at times dramatically, depending on the amount and type of motion involved. And whether the camera is moving, the camera is (mostly) stable but something in the image is moving, or ... both.

Also, it's best used on shorter segments than long ones, as it tends to get better results. It isn't a direct replacement for in-cam stabilization unfortunately.

Neil

[johnl33044717]

Thanks for the response! Will try with shorter segments.

If you (or anyone else) has more info and my other questions very happy to hear from you! 

[johnl33044717]

One thing that seems to stop the image from jumping is to set high quality Playback in the program monitor. (Found this here, with a lot of other people having same issues and several answers: https://adobe-video.uservoice.com/forums/911233-premiere-pro/suggestions/39017533-warp-stabilizer-of...) 

[Ann Bens]

2) In general what are the best settings of the stabilisation effekt? (e.g. Footage of birds flying, kamera sometimes zooming and also turning)

By @johnl33044717

There are no best settings. it's all about experimenting.

But such a clip is going to be a big challenge.

Warp Stabilizer is all about stabilizing short (few seconds) hand held footage. Not one with the camera all over the place.