Copy link to clipboard
Copied
I worked on one sequence without proxies, but it was taking too long to work on it so I decided to make proxies for the rest of the project. However I noticed that when I switch views from proxie to full res the clips don't match the timing (they are the same clip, but the part in the sequence is not the one I had before). Some of the clips work just fine, but the ones I edited before I had proxies are all over the place.
Copy link to clipboard
Copied
How about when you turn off the proxies via the monitor button, is it playing back OK then?
Copy link to clipboard
Copied
That's how I found out what was going on since the exported version didn't match what I edited. So I used the monitor button to check it. It's not with every clip, though.
Copy link to clipboard
Copied
How did you make the proxies.
Copy link to clipboard
Copied
I right clicked the clip - Create Proxy - H.264 1024x540
Copy link to clipboard
Copied
This happend to me when I created 25 fps proxies for 50 fps original files using Mercury Playback Engine Software Only.
When using GPU it was fine.
Copy link to clipboard
Copied
The clips that I'm using was a screen recording - it was 23.46fps and after the proxies it became 22.93fps...
But I couldn't choose it on the preset - should I have created a preset for it then?
Copy link to clipboard
Copied
That is the problem: framerate for proxies need to be the same as the full resolution.
Best is to make proxies inside Premiere: Select clip in Project window > right click > proxy > create proxy (use Cineform or Prores)
Copy link to clipboard
Copied
you might want to conform your sources to a standard frame rate before you make the proxies. Certainly a smart move if you anticipating combining any of the material with other frame rates.